Mettler Toledo ACM500 Guia De Instalacion página 36

3.6.3. PROFIBUS DP Connection
The PROFIBUS PLC option fits into the PLC interface slot in the ACM500 main board. This option
board is shown in Figure 3-21.
Figure 3-21: PROFIBUS Option Board
The PROFIBUS connection to the ACM500 is made using a right-angle nine-pin connector inside the
enclosure. This connector is a standard Siemens part # 6ES7 972-0BA41-0XA0 or equivalent (not
supplied by METTLER TOLEDO). There are two nine-pin connectors on the PROFIBUS board – use
the lower of the two connectors shown in Figure 3-21. The completed connection is shown Figure
3-22.
Figure 3-22: PROFIBUS Connection in ACM500
64061976 | 08 | 11/2019 3-17
METTLER TOLEDO ACM500 Installation Manual