Ferm MSM1040 Traducción Del Manual Original página 15

fence (9) until the leg of the angle gauge is
flush with the saw blade along its entire length;
4. Retighten all four fence bolts (51) again.
Subsequently check the position of the angle
indicator (17). If necessary loosen the pointer
using a Philips screwdriver, set to position 0°
on the scale for mitre angle (16) and re-tighten
the retaining screw.
5. MAINTENANCE
Always make sure that the machine is
not connected to the mains electricity
when you carry out any maintenance of
the mechanism.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt. Remove very persistent dirt using a soft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia,
etc. Chemicals such as these will damage the
synthetic components.
Cleaning the protective guards
Always check the protective guard (4) and
retractable protective guard (5) for debris before
using the machine. Remove old sawdust and
splinters using a brush or similar tool.
Replacing the table insert
Immediately replace damaged table
inserts.
With a damaged table insert (13) there is a risk of
small parts getting stuck between table insert and
saw blade, blocking the saw blade. To replace the
table insert:
1. Remove screws of table insert using a Philips
screw driver. If required, adjust mitre and bevel
angle to obtain access these screws;
2. Remove table insert;
3. Install new table insert;
4. Tighten the screws using a Philips screw
driver.
Slide rails
Dirt can damage the slide rails (25) and thereupon
the operating of the machine.
• Clean the slide rails regularly with a soft cloth;
• Drip some lubricating oil on the slide rails;
• Move the mitre saw forwards and backwards
so the oil spreads over the complete rails.
ENVIRONMENT
To prevent damage during transport the machine
is delivered in sturdy packaging. The packaging
is made of recyclable material wherever possible,
so make use of the possibility of recycling the
packaging. When you replace a machine, take the
old one to your local dealer. Here it will be dealt
with in an environmentally friendly way.
Damaged and/or disposed of electrical
or electronic devices must be dropped
off at recycling stations intended for that
purpose.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
WARRANTY
Read the warranty conditions on the separately
supplied warranty card.
The product and the user manual are subject
to change. Specifications can be changed
without further notice.
15