Omega Lift Equipment 60120 Manual De Instrucciones De Funcionamiento página 4

Bleeding / Venting Trapped Air
With the release valve in the OPEN position (3b above) and with ram fully lowered, remove the oil filler plug. Insert
handle into the handle sleeve; then pump 6 to 8 full strokes. This will help release any pressurized air which may be
trapped within the reservoir. Oil level should be even with the bottom of the oil filler hole. Reinstall the oil filler plug.
Assembly
Model 60120: (Refer to Figure 3)
Note: Do not tighten any bolts unless told to do so.
1. Attach base legs (1) and lower cross member (4) to upright channels (2) with bolts, flat washers, lock washers
and nuts (3). Hand tighten only.
2. Attach support links (5) to the base (1) and upright channels (2) with bolts, flat washers, lock washers and nuts (3).
3. Carefully slide bed frame (6) down to lowest possible position between the upright channels (2).
4. Attach screw hooks (7) to the jack bracket (8) with nuts (9) as shown in figure 3. Leave nut untighten to provide
easy spring attachment.
5. Slide the jack bracket (8) down between upright channels (2) onto the bed frame (6).
6. Attach upper cross member (10) to upright channels (2) with bolts, flat washers, lock washers and nuts (11).
7. Attach one end of the springs (15) to the axles of upper cross member (10) and the other end to the screw hooks
(7) on the jack bracket.
8. Carefully place the bottle jack (16) between the head plate of upper cross member (10) and jack bracket (8).
Tighten the nuts (9) that hold screw hooks (7) to prevent jack from inadvertently falling out.
9. Tighten all applicable nut and bolt assemblies.
10. Carefully bring the bed frame (6) up and secure it with pins (9).
11. Place the Arbor Plates (17) on Bed Frame (6).
12.The press is now ready to use. Don't forget to insert the handle (18) into handle sleeve of bottle jack.
NOTICE: Before disassembly, carefully slide bed to its fully lowered position.
Size of Hardware Kits
3 bolt M10x25
flat washer M10
lock washer M10
nut M10
9 nut M8
11 bolt M16x120
flat washer M16
lock washer M16
nut M16
11
18
19
3
5
Qty
8
8
8
1
8
4
4
8
4
4
Figure 3 - Assembly Illustration for model 60120
10
16
15
7
9
8
6
2
4
4
17