Daily Maintenance - NSS Enterprises CHARGER 2717 DB Instrucciones Originales

Brush Switch
 The brush switch is located on the left side of the
control column and it turns the brush on and off.
 There is also a tilt switch in this circuit located
under the brush head that only allows the brush to
be turned on when the brush head is in the
operating position.
Circuit Breaker
 There is one master circuit breaker located below
the brush switch on the control column.
Brush Head
 The brush motor, Filter Bag and Flexiwall shield
are located at the front of the machine.
 The bag connects directly to the Flexiwall shield
and has a snap that retains the rear of the bag.
MAINTENANCE
ALWAYS turn OFF all machine switches
before performing any maintenance or
repairs to any equipment.
Check the tension of the Drive Chain after the
first 100 hrs of use and then every 90 days or 300
hours as needed. For the chain tightening
instructions see the maintenance section called
90 Day Maintenance (300 Hours).

Daily Maintenance

Never leave the machine sit with a used pad
installed. This can cause the pad driver to warp.
Pad Installation / Changing
There is a wide range of pads available for many
different burnishing applications. Consult your local
NSS authorized distributor for application
recommendations.
 Lift the front of the machine up to the 90-degree
position to view the pad driver and pad.
 Make sure that the correct pad (7/8" to 1" [22mm to
25.4mm]) X 27" [68.6 cm] is being installed.
 Place the pad flat on the floor, and remove the
center hole of the pad, step on the center of the
pad to compress the edges around the center hole.
This allows for easier installation of the pad
centering cup.
 With the machine in the pad changing position,
carefully center the pad on the driver.
Caution: Pads must be installed concentric (evenly
aligned) with the outside edge of the pad driver.
Failure to follow these precautions will cause
excessive machine vibration, a reduction in pad life
and produce unsatisfactory burnishing results.
 Place the pad grabber in the center hole of the
pad.
 Holding the pad driver and pad, push on the pad
grabber until the spring clip has clicked twice.
Caution: Failure to install the pad grabber tightly
may allow the pad to be thrown from the driver.