Fein MULTIMASTER MSxe 636 II Manual De Instrucciones página 11

MSxe/MSx 636 II - Buch Seite 11 Mittwoch, 3. September 2003 4:28 16
MSxe 636 II / MSx 636 II
Typical application: wood, plaster board
and soft plastics. Not suitable for metal
(e. g. nails) and stone.
Only clamp the E-Cut saw blade and saw
in a straight position. For fixation use a
tightening screw with a large disc. Care-
fully remove the protective coating.
Always set the E-Cut saw blade straight (at
90°) and guide it in the gap without tilting.
Always guide the E-Cut saw blade along
the cutting line without exerting any pres-
sure.
When plunging and sawing with a slight
pendulum motion, make sure that suffi-
cient chip removal is provided for.
Keep a certain distance away from hard
metals (stone/metal) (approx. 3 mm),
since there is increased danger of the
outer saw teeth breaking off.
Scraping
Typical application: Scraping off old var-
nish or adhesives. Removing glued carpet-
ing, e. g. on stairs or other small to
medium-sized surfaces.
Select medium/high/oscillation fre-
quency.
For further information and tips on polish-
ing, rasping, cutting and separating, please
consult the brochure, "Ideas for practical
applications".
Cleaning and care.
!
Risk of injury
by switching the tool ON unintentionally.
Before cleaning, pull out the mains plug.
Carry out the following once a week, or
more often if the power tool is used more
frequently:
Clean the venting openings.
Blow out the motor space from outside
with dry compressed air.
Maintenance and repairs.
!
Risk of injury
Service, testing and repairs may only be car-
ried out by electrical engineers in conformity
with the regulations valid in the respective
country.
Maintenance and repairs.
We recommend our customer service
department (repair centre), FEIN author-
ised service centres and agencies.
Addresses can be found at the end of
these operating instructions and in the
enclosed safety instructions.
Please hand these operating instructions
to the repair centre. An overview of spare
parts can be found at the end of these
operating instructions.
Upon request a repair manual is sent to
the electrical engineers.
Only use original FEIN spare parts.
Spare parts.
The overview of spare parts is at the end
of these operating instructions. Quoting
the parts no. (1), reference no. (2) as well
as the number of spare parts (3) facilitates
the ordering procedure.
EN
11