Optional Attachments; Mulching" Kit; Batteries; Battery Charger - ST MP2 500 Li D48 Serie Manual De Instrucciones

Ocultar thumbs Ver también para MP2 500 Li D48 Serie:
Tabla de contenido

Publicidad

5.
The danger LED lights up
on the display (Fig.24.A).
6.
The cut grass is no
longer collected in
the grass catcher.
7.
Mowing is difficult.
8.
Excessive noise and/
or vibration is experi-
enced whilst working.
9.
Battery power re-
serve is low.
10. The battery charger is
not charging the battery.

15. OPTIONAL ATTACHMENTS

15.1

"MULCHING" KIT

Finely chops the cut grass and leaves it on the
lawn, instead of collecting it in the grass catcher
(for machines equipped with it) (Fig.25).
15.2

BATTERIES

Different capacity batteries are available to suit
specific operating requirements (Fig.26). The
list of approved batteries for this machine can
be found in the "Technical Data" table.
The thermal protection has tripped
due to overheating of the machine.
The cutting means hit a foreign object.
The inner part of the chassis is soiled.
The cutting means is not in good state.
Cutting means fittings are loose or
the cutting means is damaged.
Severe working conditions requiring
greater current absorption.
Battery is insufficient for
operating requirements.
Battery is not correctly inserted
in the battery charger.
Unsuitable environmental conditions.
Dirty contacts.
The battery charger is not energised.
Faulty battery charger.
Wait for at least 5 minutes and restart the
machine.
Immediately turn off the motor
and remove the safety key.
Check if there is any damage and
contact a Service centre to replace the
cutting means if necessary (par. 8.1).
Clean the inner part of the chassis to
facilitate the evacuation of the grass
toward the grass catcher (par. 7.3.2).
Contact the Authorised Service
Centre for the sharpening or
replacement of the cutting means.
Immediately turn off the motor
and remove the safety key.
Contact the Authorised Service Centre for
checks, replacements or repairs (par. 8.1).
Optimise operations (par. 7.2.1).
Use additional batteries or batteries with
extended power reserve (par. 15.2).
Check it is correctly inserted (par. 7.2.3).
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual).
Clean the contacts.
Check it is plugged in and the
power socket is energised.
Replace with an original spare part.
If the problem persists, refer to the
battery/battery charger manual.
15.3

BATTERY CHARGER

Device used to recharge the battery (Fig.27).
EN - 13

Publicidad

Tabla de contenido
loading

Tabla de contenido