Tips And Advice On Operation; Battery Replacement - SOMFY Sonesse 30 ZIGBEE Li-ion Manual

EN

3.3. TIPS AND ADVICE ON OPERATION

Observations
The driven product does
not operate.
The driven products
stops before its end limit

3.4. BATTERY REPLACEMENT

͉
͉
Contact Somfy for battery model's recommendation.
Precaution
Replacement of the battery by an identical model only, must be carried out by a professional of
the motorization and the automation of the habitat.
Attention
• Do not use tools that could damage the drive when replacing the battery.
• Do not cut or damage the antenna cable.
1) If the drive is fixed to the tube, disassemble the driven product
to access the self-tapping screws or steel pop rivets (motor
drive wheel side) and remove them.
2) Grab the motor head and pull out the drive by sliding it out of
the driven product tube.
3) If necessary, offset the ring gear on the actuator tube to access
the two T6 torx screws or cruciform screws and unscrew the
motor head.
4) Remove carefully the motor head from the drive tube taking
care not to damage the wires and disconnect the battery.
5) Grab and remove the used battery by sliding it out of the drive
tube taking care not to damage the wires.
6
Possible causes
The control point battery is
low.
Drive battery is low and
requires charge. Red LED
blinks 3 times when any
button of a paired control point
is pressed.
Thermal protection of the drive
is on .
Battery is low. Red LED blinks
3 times when any button
of a paired control point is
pressed.
Copyright 2017 - 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Sonesse 30 WF Zigbee Li-Ion
Solutions
Check the battery and replace it as
required.
Plug in the charger.
Wait for the motor to cool down.
Charge the battery.
1
2
3
4
5