Sanitaire HydroClean SC930 Manual De Instrucciones página 12

M INTEN NCE: BRUSH ROLL ND CH MBER
! !
WARNING
Brush may start unexpectedly. To reduce the risk of injury from moving parts, turn power
OFF and unplug floor washer before cleaning or troubleshooting.
1
3
With warm water, rinse
your brush roll cover and
brush roll.
TIP:
Running your floor washer with a wet brush roll will help the brush roll dry faster.
The trigger should not be pressed.
NOTE:
The brush roll is not dishwasher or automatic washing machine safe.
Please follow cleaning instructions.
6
Replace brush roll by inserting the brush roll
end into the right side of the nozzle. Then
lock the pull-tab into place by pressing
downward.
12 www.sanitairecommercial.com
Grasp brush roll
cover and press
latch while
pulling upward
to remove.
4
If your brush roll cover is
dirty, clean with a rag
or towel.
2
5
Let your brush roll and
brush roll cover dry before
reassembling.
7
Replace the brush roll cover by first lining up
both brush roll cover tabs with the edges of
the nozzle. Then press the brush roll cover
back into place until you hear a click.
Pull brush roll
out by grabbing
the brush roll
tab and pulling
upward.