Troubleshooting - Sanitaire HydroClean SC930 Manual De Instrucciones

TROUBLESHOOTING

!
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
Possible causes
Problem
Solution tank may be empty.
Solution tank may not be
seated completely.
System isn't completely primed.
Reduced spray
OR
Brush window is not latched
no spray
in place.
Not holding trigger to spray solution.
Spray tips on nozzle clogged.
Tanks may not be seated properly.
Dirty tank has picked up
maximum amount of dirty water
Loss of
and has reached full line.
suction
Brush cover is not latched
power
in place.
Debris channel in nozzle is clogged.
Filter clogged by debris.
Brush roll is not installed properly.
Brush roll is
Floor washer is standing upright.
not turning
Obstruction has caused brush roll
to stop.
Obstruction has caused brush roll
to stop and shut down floor washer.
Handle not inserted properly into
body of floor washer.
Floor washer
won't
Brush roll is missing, misaligned or not
a genuine Sanitaire replacement.
turn on
Filter is missing, misaligned or not a
genuine Sanitaire replacement.
Dirty tank is full.
Filter is clogged.
Floor washer Cap of clean water tank is not closed
properly.
is leaking
Too much water applied.
Floor washer
is streaking
Previous floor care products used.
Brush roll cover not on tight.
Floor washer
Filter is clogged.
is not
drying floor
Continuous use with solution trigger
depressed.
Remedies
Refill tank.
Turn power OFF / Remove and reseat tank.
Hold trigger for 10 to 15 seconds. If no spray after 15 seconds,
turn power OFF, unplug power cord, then plug back in. Turn
power ON and repeat holding trigger for 10 seconds.
Turn power OFF / Unplug floor washer and re-install
brush window.
Hold trigger continuously while using the floor washer.
Use a paper clip to clean the spray tips located
underneath the brush roll window.
Turn Power OFF / Remove both tanks and reseat
them so they fit properly.
Empty dirty tank and make sure to make slow cleaning
passes back and forth while cleaning.
Turn Power OFF / Unplug floor washer and re-install
brush cover.
Clean the channel with a paper towel.
Remove debris clogging the filter screen and clean the filter.
Turn Power OFF / Unplug floor washer and follow instructions
on page 12 for replacing brush roll.
Recline floor washer to make brush roll turn on.
Turn Power OFF / Unplug floor washer and remove brush
window and brush roll cleaning hair and string off of brush ends.
Unplug floor washer to reset the system. While the machine i
s unplugged, remove the brush cover and brush roll cleaning
hair and string off of brush ends.
Remove the handle and re-insert into the body of the
floor washer making sure to push down until you hear a "click."
Make sure genuine Sanitaire brush roll is properly installed.
Make sure genuine Sanitaire filter is properly installed.
Empty tank.
Clean or replace filter.
Remove the clean water tank and re-apply the cap.
Go over area without spraying down water.
Contact product manufacturer regarding how to remove.
Remove brush roll cover and reattach making sure
latch clicks in place.
Remove filter and clean thoroughly. See EMPTY DIRTY WATER.
Release solution trigger and use an additional forward
and reverse stroke over area cleaned.
1-800-800-8975 13