Cleaning Hard Floors - Sanitaire HydroClean SC930 Manual De Instrucciones

CLE NING H RD FLOORS
!
WARNING
Do not plug in the Sanitaire
familiar with all instructions and operating procedures.
1
Plug floor washer
into a properly
grounded outlet.
4
10 seconds
Before each use, hold the
solution spray trigger for 10
seconds to prime the system with
cleaning solution. LED lights
illuminate when holding the
trigger.
NOTE: When solution is flowing,
you will see bubbles forming at
the edges of the brush roll
window.
TIP:
For overly challenging and stuck-on messes on your hard floors, hold the
®
Sanitaire Hard Floor Washer over the mess. Using short passes while holding the trigger
allows the multi-surface brush to go to work.
®
Hard Floor Washer until you are
2
Turn the machine ON. The dry
vacuum will turn on. To turn OFF,
press the button a second time.
5
To clean, hold the solution
spray trigger to apply
solution on both forward
and backward passes.
3
Recline the body of the floor
washer backward to start the
brush roll spinning.
To stop the brush roll
spinning, you will need to
stand the floor washer upright.
6
To dry hard floors
faster, release the
trigger and clean a
second pass without
dispensing solution.
1-800-800-8975 7