STERILISATION MODE
It projects an airflow that is capable of disinfecting both the
environment and fabrics and surfaces (floors, walls, furniture...).
This purifier offers two levels of sterilisation:
- SIMPLE STERILISATION. 9-hour specific sterilisation mode for
users who want the room to undergo deep disinfection while it is in use.
See the full instructions included in the STERILISATION MODE section.
- INTENSIVE STERILISATION. Intensive specific sterilisation mode
for users who want the room to be fully sterilised in a short period of
time. NOTE: This mode cannot be used in the presence of people
or animals.
See the full instructions included in the STERILISATION MODE section.
Timer selection
In any of the operating modes described above (except the sterilisation modes) you
can press the Timer icon to operate the purifier for a programmed period. The icon will
start to flash. The timer period can be adjusted from a minimum of 1 hour to a maximum
of 12 hours. Each press of the icon increases it by 1 hour, as shown in the example.
To confirm, press the Timer icon for 2 seconds or the appliance will automatically
confirm it after 10 seconds have elapsed.
Once the programmed period has ended, the purifier will progressively reduce its
speed until it stops, at which point it enters standby mode.
NOTE
continue its programme.
NOTE
period by pressing the Timer icon and following the same process
explained above.
NOTE
: To cancel Timer mode, press the Timer icon again for longer than two
seconds. The purifier will cancel the countdown and continue to operate in
the previously selected mode.
Warning
previously selected. If you click the icon in standby, the timer will not be
activated.
Switching off
Press ON/OFF at any time to switch off the appliance.
48
: If the filtration mode is changed in timer mode, the timer will
: At any time you can view and/or change the programmed
: This option is only available if an operating mode has been
1h
2h