Temperature Models - Transtherm MAS 1T Manual Del Usuario

Temperature settings for 3 temperature models
The temperature control(s) and setting(s) are adjusted from your wine cabinet's
settings panel, as shown below:
Chilling temperature
display
Service
Lighting (LED1)
temperature switch
3 temperature cabinet models have 3 zones:
• The first "low" zone, called the chilling compartment. Its original set
temperature is 7°C (44°F), on leaving the factory.
It is possible to adjust the temperature setting. Please note, however, that
there is no upper or lower limit.
Please note: Its recommended setting range is 6°C to 8°C (42°F to 46°F).
To adjust the temperature of your chilling zone:
Please note: Once you see the display flash during setting, you have 50 seconds to
change or confirm your setting, otherwise you will have to restart the process.
If the setting has not been recorded, your cabinet will retain its original settings.
Press and hold down the
Press , "F4" will appear on the display ("F4": chilling compartment tem-
perature setting).
Press to read the set temperature.
Press to increase the set temperature, or
Press to reduce the set temperature.
To record your setting, press the button
temperature is displayed.
Otherwise, it will be necessary to restart the process.
"ST" allows you to set the wine
maturing temperature (for 1 and 3
« ST » temperature models) or the upper
section (for multi-temperature
models).
Allows you to change from "ST" to "F4" then "H4".
Pressing! for
"F4" Allows you to set the tempera-
5 seconds ture of the chilling compartment (for
« F4 »
3 temperature models) or the lower
section (for multi-temperature
allows you
models)
to access:
Allows you to change from "ST" to "F4" then "H4"
"H4" Allows you to activate or disa-
« H4 » ble the warning alarm, if a malfunc-
tion occurs.
Hot circuit indicator light
(Red)
Maturing temperature
display
Keyboard
Lighting (LED2)
key for 5 seconds. "St" will appear on the display.
Lighting ON / General ON / OFF
OFF switch
switch
Cold circuit indicator light
(Green)
and hold for 5 seconds until the
Pressing Set: Allows you to read
the set temperature of the "ST"
setting.
Pressing Set twice: Allows you to
return to the "ST" display
Pressing Set: Allows you to read
the set temperature of the "F4"
setting.
Pressing Set twice: Allows you to
return to the "F4" display.
Pressing Set: Allows you to read
the "H4" setting value:
H4=O means that the warning
alarm is active.
H4=1 means that the warning
alarm is disabled
Pressing Set twice: Allows you to
return to the "F4" display.
P10