teutonia Fun Manual De Instrucciones página 11

Removing the hood cover
Before washing, both hood bars must be removed
from the cover.
Loosen the screw with a screwdriver and remove the
snap. Now pull the cover bar out of the joint and out of
the hood cover. After washing, reassemble in reverse
order.
Make sure that each cover bar is pushed into one of
the stitched guides. The front and back bars must not
be mixed up.
Unfolding the chassis
Pull the handle 1 up until the handle lock 2 clicks into
place.
WARNING: Ensure that all the locking de-
vices are engaged before use.
Folding the chassis
Simultaneously pull up both tensioning sleeves 1 on
both sides as far as they can go and at the same time
press the safety button on the right tensioning sleeve.
Then press the handle 2 down. Now you can addition-
ally make the storage dimensions smaller by folding
down the upper part of the handle.
Mounting and removing the wheels
Rear wheels:
To detach the rear wheel:
– Press the locking (7) and pull the wheel off the axle.
To attach push the wheel onto the axel.
Check that the wheel is proparly locked by pulling!
Front wheels:
To detach press the locking (10) and pull the steering
axle out. To attach, push the axel into place.
Check that the wheel is proparly locked by pulling!
11