teutonia Fun Manual De Instrucciones página 13

Adjusting the back rest
Adjusting the foot rest
Press and hold the foot rest ar-
rester there are three positions
available for the foot rest.
Using the 5-point harness
You can position the shoulder harnesses at 3 levels.
Always use the position closest to the shoulder level
of your child. To open the harness press the central
button on the buckle. To adjust the shoulder/ weist
harness pull the free ends of the strap.
Adjusting the restraints
Pull up on the arrester of
the back rest to change its
inclination angle (4 seating
and prostrate positions +
folding position all the way
forward).
Safety bar
Push the insert pieces on the safety bar through the
slots in the seat cover into the receptacles beneath,
which are located in the armrests. Make sure that the
safety bar has clicked into place on both sides. To re-
move it, press the release buttons on the insert piec-
es. In order to make it easier for your child to get in
and out, it suffices to release and fold up one side of
the bar.
Special features of the model variations
justment screw on the brake lever.
Note: The brake should only be used to slow the
wheels, not to block them.
Warning: When reordering rear wheels, please ensure
that the supplier is aware of the deceleration brake as
the brake requires a special brake disc. The foot brake
will not function if the wrong brake disc is used!
Maintenance:
-
The brake pads can wear out during use and the
brake needs maintenance. The setting of the brake
can be done on the brake lever when the lock nut is
loosened and the adjusting bolt is unscrewed.
-
If the left and right braking effect differs, tilt over the
stroller on soft ground and adjust the bolt under the
brake housings near the wheels.
-
The bolt can be screwed and unscrewed by using an
8mm jaw wrench. Unscrewing the bolt increases the
braking effect. The setting has to be made so that
the braking effect is the same on both wheels.
Models with deceleration
brake:
You are able to control the
deceleration brake using
the brake on the handlebar.
The braking action can be
fine-tuned using the ad-
13