Publicidad
#2. Instalación del conjunto biela derecha.
*
RODAMIENTO,
(No incluido)
*
CIRCLIP
(No incluido)
*
SELLO, ancho 1.6mm
!
Engrase
el cono
del eje
SÓLO NECESARIO CON CUADROS BB30 (EL RODAMIENTO
SE INSTALA DIRECTAMENTE EN EL CUADRO).
*
EN CUADROS DE PRESS FIT 30 LA CAZOLETA SUSTITUYE AL
RODAMIENTO, SELLO Y CIRCLIP.
#3. Fijación del cojunto biela derecha.
Apriete el tornillo de la biela derecha
a 35 Nm usando una llave allen
dinamométrica de 8mm.
Página 2
CAJA 68mm: ESPACIADOR 8,5mm
CAJA 73mm: ESPACIADOR 5,5mm
30x42x7
ESPACIADOR
11.5mm
(Not included)
Allen 8mm
35 Nm
MAS (Micro Adjustment Spider) SETTING (Cont.)
Read and fully understand Q-Ring´s manual before installation
For "regular" OCP settings place the bolts and nuts in positions
marked with number 1 as shown in the next figure.
1
In "regular" OCP setting, screw one bolt from the inner side of the
spider into the threaded hole marked as 1*.
For "OCP+1/2" settings place the bolts and nuts in positions marked
with number 2 as shown in the next figure.
2
In OCP+1/2 settings one hole is hidden under the crank arm, screw
one bolt into this threaded hole marked as 2* from the inner side of the
spider.
1
1
2
2
1
*
1
2
2
1
1
The marked holes with arrow peaks (
"ALTERNATIVE BOLT PLACEMENT" positions for "OCP +1/2" settings.
Check that bolts are placed in those positions after OCP+1/2 installation.
2
2
1
1
2
1
1
2
2
▲
) and number 2 are the
Page 5
*
2
Publicidad
