Lorentz PS2-100 Guía De Uso página 5

Pumping Water
Operation
Ensure the pump is fully submerged in water.
Switch on the pump.
The system will run.
LEDs (lights) on the controller tell you:
The pump is running. To turn off the pump,
use the switch.
The pump is turned off. To start the pump,
use the switch.
An accessory has stopped the pump.
Check the float switch / dry run sensor.
An error has occurred. Disconnect and recon-
nect your pump, check for enough solar power
input.
This indicates a permanent LED.
This indicates a flashing LED.
English English
4