First Use Of The Electric Servetto I3 - SERVETTO 805.23.762 Montaje

If the control unit continually emits "BEEP" when the power supply is connected, check that the arm to control unit cables (No.
11 and 12 in Fig. 3) have properly been connected.

5.5 FIRST USE OF THE ELECTRIC SERVETTO i3

Adjust the length of the tube as shown in Fig. 20, then lock the clothes rail tube in place by rotating both tubes in opposite
directions.
Press the remote control button (letter N in Fig. 1), and the Electric Servetto i3 will lower.
Insert the plastic tube end caps (letter O) into each side of the tube (letter H). Next, insert the tube and tighten the screws in the
corner brackets (Fig. 21).
WARNING: If the Electric Servetto i3 does not work and the control unit "BEEPS" twice, check that the security
sensors have correctly been installed or that the same have correctly been disabled (Chap. 4).
Fig. 20
Fig. 21
16
EN