Top Innovations SteamFast SF-434 Manual De Instrucciones página 10

CONNECTING FABRIC/LINT BRUSH
The Fabric/Lint Brush is designed to work with steam to
remove lint and other loose particles from fabrics.
CAUTION: Ironing Plate becomes extremely hot during
use. In order to avoid burns or other injury, Fabric/Lint
Brush should only be connected before Ironing Plate has
heated. Do not attempt to connect Fabric Brush while unit
is emitting steam.
Do not attempt to remove Fabric/Lint Brush until Ironing
Plate has fully cooled (at least 30 minutes).
1. Slide Fabric/Lint Brush over Ironing Plate as shown
(FIGURE 6). Press it firmly on until hook on bottom
of Fabric/Lint Brush (FIGURE 6-A) catches onto tab below
Ironing Plate (FIGURE 6-B). Fabric/Lint Brush should
now be secured in place.
2. In order to remove Fabric/ Lint Brush, pull outward on hook
while simultaneously pushing upward on Fabric/Lint Brush
until hook slides over tab. Continue pulling upward on
Fabric/Lint Brush to slide it off of Ironing Plate.
NOTE: Fabric/Lint Brush must be removed in order to
use Ironing Plate to press fabrics.
FILLING UNIT WITH WATER
1. Remove Water Tank Lid from Water Tank by simply lifting it straight up; there is no lock or
release that holds it in place.
2. Using a convenient cup or water container, fill Water Tank with water. For maximum capacity
(48 oz. / 1,420 ml.), fill Water Tank completely to top. Use care so that water doesn't overflow.
NOTE: To prolong the life of your 2-in-1 Fabric Steamer & Iron, it is highly recommended
that distilled or de-mineralized water be used - this will help to minimize mineral build-up.
3. Replace Water Tank Lid. Note that it will fit onto the Water Tank correctly only one way.
NOTE: If Water Tank runs low during operation, it can be safely refilled with water any
time - it is not necessary to turn the unit off.
NOTE: It is not necessary to empty water from Water Tank between uses - however, it is
highly recommended. Storing unit dry, then beginning each use with fresh water will help to
minimize potential mineral build-up.
10
U
SING THE
2- -1 F
IN ABRIC
Top Innovations, Inc.
S & I
TEAMER RON
A
B
FIGURE 6