Top Innovations SteamFast SF-434 Manual De Instrucciones página 11

2- -1 F
IN
GENERAL STEAMING
NOTE: Be sure that Water Tank has been filled and, if desired, the Fabric Brush is connected
before following these steps.
1. For first-time use, remove protective plastic cover that is shipped on electrical plug. Plug power
cord into a convenient 3-prong electrical outlet.
CAUTION: This unit uses a grounded (3-prong) electrical plug. Use only in properly
installed 3-prong electrical outlets. Do not attempt to alter plug or circumvent this safety
feature in any way.
2. Set Lighted On/Off Switch to "ON" position, and verify that switch is illuminated. The Heating
Indicator Light will illuminate as well, indicating that heater is active.
3. After approximately 45 seconds of heating time, Heating Indicator Light will turn off. Ironing
Plate is now heated and Steam Nozzle is ready to begin producing steam.
NOTE: During use, Heating Indicator Light may cycle on and off. This is a normal effect of
the unit working to maintain a steady temperature.
4. Make sure that Self-Clean Switch is set to "OFF" position, then press and hold Steam Button.
Unit will begin pumping water from Water Tank into Steam Nozzle.
NOTE: For normal steaming, Self-Clean Switch should always be set to "OFF". The "ON"
setting is only used when flushing mineral build-up out of Steam Nozzle. Refer to
"Self-Cleaning" section on Page 13 for details.
CAUTION: Always be sure that Steam Nozzle is pointed in a safe direction (away from
yourself, other people, pets and plants) before pressing Steam Button.
5. It will take 20-60 seconds for unit to begin producing steam, depending on length of time that unit
has been inactive. For first-time use, or if the unit has not been used for a long period of time, it
will take longer for water to be pumped through Hose. Eventually, Steam Nozzle will begin
producing a flow of steam.
NOTE: When first starting up, unit may make a loud pumping sound as air and water are
pushed through Hose. Sound will fade once air is expelled and Hose is filled with a steady
flow of water (approximately 20-30 seconds).
Pumping sound should remain inaudible during normal use, until Water Tank begins
running low. Refilling with water will eliminate the sound again.
6. If desired, Steam-Lock Switch may be used to lock Steam Button down for a hands-free flow of
continuous steam. While pressing down Steam Button, simply slide Steam-Lock Switch forward -
Steam Nozzle will continue producing steam. To unlock Steam-Lock Switch, slide it backward
while pressing down on Steam Button.
7. Proceed with your steaming / ironing tasks. For more information and tips on steaming and
ironing, refer to Page 12.
8. When you are finished using the 2-in-1 Fabric Steamer & Iron, immediately set Lighted On/Off
switch to "OFF" position and unplug power cord from electrical outlet. Refer to Care and
Storage Guidelines on Page 13 for proper cleaning and storage procedures.
U
SING THE
S
ABRIC TEAMER
Top Innovations, Inc.
& I
RON
11