RIDGID RP 342-XL Press Tool Manual página 7

(See Specifications section) approved by RIDGID for
use.
The press cycle for Standard Series attachments is approx-
imately 4 seconds, and for Extended Series attachments
it is approximately 9 seconds. Once the cycle begins to
deform a fitting, it will automatically continue until com-
pletion, even if the run switch is released.
The Tool Status Lights indicate things such as out of
specification temperature, low battery, or maintenance
required. A work light turns on when the run switch is
depressed to illuminate the work area.
The head can be rotated 270° for better access in tight
spaces.
The tool comes with two (2) fabric loops that can be used
with appropriate attachments such as shoulder straps or tie
off lines.
ON/OFF
Fabric
Tool Status
Button
Loop
Lights
Pressure
Release
Button
Warning
Labels
Handle
Figure 1 – RIDGID RP 324-XL Press Tool and Standard
Series Jaw
Control Marking
On/Off Button
Run Switch
Pressure
Release Button
Attachment
Mounting Pin
Sleeve - "Extended"
Series Configuration
Sleeve - "Standard"
Series Configuration
Figure 4 – Controls Chart
999-999-207.10_REV. A
Scissor Style
Sleeve
Jaws
Housing
Work
Light
Jaw
Attachment
Side-Plate
Run
Mounting
Switch
Pin
Battery
Description
Main tool power switch. Press to turn ON/OFF.
ON: Press button until light turns ON. See Figure 5 – Tool Status Lights.
OFF: Press button until light turns OFF. Tool will automatically turn OFF if left unused for ten
(10) minutes.
Depress to press fittings. Release when tool locks on. Releasing the switch will not stop the
—
tool once it has locked on. This assures consistent, repeatable press connection integrity.
Allows tool to be released without completing press. If used, press connection is not complete
and must be repeated.
— Holds attachment to tool. See Figure 6.
Sleeve rotates 90° between "Extended" and "Standard" configurations for use with appropriate
attachments (see Changing Tool Configuration ("Extended"/"Standard")).
Sleeve rotates 90° between "Extended" and "Standard" configurations for use with appropriate
attachments (see Changing Tool Configuration ("Extended"/"Standard")).
RP 342-XL Press Tool
Warning Label
Figure 2 – ON/OFF switch and Tool Status Lights
-
27.2
490 32 k
20XX
Figure 3 – Machine Serial Number - The circled digits indi-
cate the year (YY) and month (XX) of manufac-
ture.
ON/OFF Button
Tool Status Lights
5