Cequent Performance Products 76116 Instrucciones De Instalación página 4

1. Lower Muffler- Lower muffler by removing the (2) rearmost rubber
isolators. Note: Spray a lubricant on rubber hangers to make them
slide off metal pins more easily. NOTE: Be careful that exhaust is
supported before removing rubber isolators. Note: Removing the
exhaust hanger will help with the heat shield trim, be sure to have
reinstalled before raising the hitch into place.
Exhaust hanger bolt
can be removed with
a 13mm socket
2. Trim Heat Shield- Using tin snips cut the heat shield as shown in
figure 2, (both sides).
©2017 Cequent™ Performance Products, Inc. - Printed in Mexico
Remove rubber
isolator from these point
3"
7"
1. Note: If the vehicle has bolt on exhaust tips, remove with a T-30
torxbit socket. 2 bolts per side. Push the exhaust tip forward then
remove to the rear.
3. Install Hardware - Using the fish wire install items 1 through 4. As
shown in figure 1 Note: The long carriage bolt goes in the forward
attachment hole. Note: Leaving the bolt inside the frame for the rear
most (inside of the frame rail) attachment will help when raising the
hitch into place. Note: If foam tape is covering the attachment holes
remove tape. Note: Keep the fish wire attached to the hardware.
Bolt holes bottom
of the frame
Sheet 4 of 15 76116NP
Access
hole
Bolt hole side
of the frame
1-9-17 Rev. A