Rechargeable Battery Model; Cleaning - Cuda Fiberoptics LED ROVER Instrucciones De Uso

7.

RECHARGEABLE BATTERY MODEL

The rechargeable model lightsource differs from the standard only by the use
of rechargeable batteries. The rechargeable batteries provided are a high
capacity "RCR123A" 3.6 volt Lithium ion battery. The charger is compatible
only with the 3.6 volt high capacity rechargeable Lithium ion batteries. The
3.6 volt high capacity batteries provided are compatible only with chargers
specifically designed for them. Do not put other types of batteries in the
charger or attempt to charge the batteries with another type of charger.
A pair of fully-discharged batteries will take approximately three hours to
reach a full charge. The indicator light on the charging cradle will show green
when the power converter powers the empty cradle.
red/orange when charging batteries and green when batteries are fully
charged. Batteries may be "topped off" to full charge even if they are not
discharged. Batteries may be left in the charging cradle when charged. (If the
cradle is not powered, the indicator will show green if a battery with even a
very low charge is inserted; the cradle must be powered for the indicator to be
true.) It is advised to keep pairs of batteries together in use and in charging so
that they both have approximately the same state of charge. Damage can
result from mixing batteries of different charge strengths either in use or in
charging. Avoid directly short circuiting a battery.
operates on 90∼260 VAC, 50∼60Hz @ 0.5A.
Fully charged batteries will operate the lightsource at full brightness for
approximately 1½ hours, followed by approximately ½ hour of usable
gradually diminishing light.
8.

CLEANING

The LED Rover is a high quality optical device. Care for it appropriately.
A soft brush with mild detergent may be used to clean the device. The lens of
the LED inside the optic port may be wiped with a swab. Avoid harsh or
abrasive material that could scratch or in any way damage the optical surface.
The LED Rover is furnished non-sterile and no sterility claims are made
regarding this product.
NOTE: Failure to follow instructions could render the device unusable
and void any warranty.
®
LIT102 CUDA
(English)
The indicator is
The power converter
Rev. I
Page 6 of 35