Technical Specifications - HK Audio PREMIUM PR:O MOVE 8 Manual De Instrucciones

7 Technical Specifi cations
MOVE 8
Max. SPL peak @ 10% THD
Frequency response +/- 3 dB
Frequency response -10 dB
Power output
Total battery operating time
Active protective circuits
LMF woofer
HF driver
Horn directivity
Active X-over
Audio in ports
Audio out ports
Tone controls
Filter presets
Bluetooth
Angles up
Pole mount
Handles
Housing
Finish
Front grille
Dimensions (WxHxD)
Weight
Battery
Battery capacity
Dimensions (WxHxD)
Weight
Charging time in MOVE 8
Charging time in optional quick
charger
Apple iPad, iPad Air and iPad Pro are trademarks of Apple Inc., registered in the U.S. and other
countries.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by Stamer Musikanlagen GmbH is under license.
All mentioned trademarks and copyrights belong to their respective owners.
123 dB half-space
65 Hz – 18 kHz
55 Hz – 20 kHz
60 W Class D
Up to 11 h (with two fully charged
batteries)
Peak and RMS sound limiter (one each
for HF und LMF)
1x 8", 1" voice coil
1", 1" voice coil
70° x 70°
2.5 kHz
2x combo XLR/ 1/4" (6.3 mm) in (Mic/
Line), 1x 1/4" (6.3 mm) (Instr.), 1x stereo
mini jack (Aux)
1x stereo mini jack (Aux)
2-band EQ for Channels 1 to 3
Guitar Cab Simulation for Channel 3
5.0
33°
1x 35 mm
1x SingleGrip, integrated
MDF
Black acrylic enamel
1,5 mm metal grille backed with black
acoustic foam
29 x 41 x 28 cm
11-27/64 x 16-5/32 x 11-3/64"
8.5 kg / 18.7 lbs
5,200 mAh
8 x 3 x 8.3 cm
3-5/32 x 1-3/16 x 3-17/64"
0.25 kg / 0.6 lbs
Around 5 hours
Around 2 hours
For USA:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance. This
transmitter meets both portable and mobile limits as demonstrated in the RF Exposure Analysis. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
except in accordance with FCC multi-transmitter product procedures.
For Canada:
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
Warning: Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery,
that can result in an explosion. Leaving a battery in an extremely high temperature surrounding
environment that can result in an explosion or the leakage of flammable liquid or gas. A battery
subjected to extremely low air pressure that may result in an explosion or the leakage of flammable
liquid or gas.
The MAX operate temperature: 45°C.
This device contains licence-excempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation
of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes :
1. L'appareil ne doit pas produire de brouillage;
2. L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
The equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. The equipment should be installed and operated with minimum distance 20 cm between
the radiator & your body.
MOVE 8 1.1
9