Publicidad
Idiomas disponibles
Idiomas disponibles
(will not fit vehicles with optional dealer installed ground effects package)
NOTE ! This is important to
assure that there is enough stud
length for washer & locknut.
(It may be necessary in some cases
to enlarge hitch hole diameter with
a round file to fit over vehicle
weldnuts.)
NOTE
*Use flat washers
as needed, you
may not need to
use all off them.
8
*It may be necessary to insert flat
washers under head of bolt also to
assure that bolt does not bottom out.
Use one of the (3) different length 3/8"
3
bolts supplied to make attachment. Mix &
4
match bolt length and flat washers so that
5
joint can be tightened without bottoming
out on transaxle mount.
Hitch bracket
Tighten 3/8"-16 Gr.5 bolt with torque wrench to 30 Lb.-Ft. (41 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2009, 2011, 2012, 2015 Cequent Performance Products, Inc – Printed in Mexico
Installation Instructions
Chevrolet Camaro
All Models, Excluding convertible
Hitch clearance hole must go over & around existing
vehicle stud/weldnut, typical both sides of vehicle.
8
*Insert flat washers as needed to
fill gap between hitch & vehicle.
6
Conical washer
Side view of forward attachment
1
2
Vehicle transaxle bracket
(cut-away to show detail)
7
3/8" Locknut
Do not let bolt bottom out
on vehicle aluminum
transaxle mount.
Figure 2.
Tighten 8mm locknuts with torque wrench to 27Lb.-Ft. (37 N*M).
Sheet 2 of 6
Part Numbers:
24850, 60266,
77223, 24893
Figure 1.
View looking rearward on
rear attachment
Vehicle aluminum
transaxle mount
24850N
10-8-15
U-Haul
Rev. D
Publicidad
