Publicidad
Idiomas disponibles
Idiomas disponibles
Install water-resistant wall
material so the
paperbound edge is at
least 1/4" (6mm) above
the finished, concave
surface of the module
8. Complete the Finished Wall
- If you have not already done so, carefully remove the protective tape from the whirlpool rim.
- Apply a continuous bead of silicone sealant to the nailing in flanges. Install water resistant wall material so the
paperbound edge is at least 1/4" (6mm) above the finished, concave surface of the module.
- Tape and mud the water resistant wall material. Install the finished wall material.
- Install the mixing valve, shower, and spout trim according to the instructions packed with the trim.
- Install any extra grab bars or towel bars to the bridging previously installed. Follow the accessory manufacturer's
instructions.
- Install the shower door according to the manufacturer's instructions.
9. Clean-Up After Installation
- When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the whirlpool
surface. Use warm water and a liquid detergent to clean the surface.
- Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners containing
petroleum distillates to remain in contact with any whirlpool surfaces for long periods of time. Remove plaster
by carefully scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. Use a
powder type detergent on a damp cloth to provide mild abrasive action to any residual plaster.
A
1011588-2-
Å Å Å Å Å Å Å Å Å Å
Å Å Å Å Å Å Å Å Å Å
Å Å Å Å Å Å Å Å Å Å
Å Å Å Å Å Å Å Å Å Å
Concave Surface
Î
Stud
Î
Î
Î
Î
Î
Î
Î
Î
Î
Î
Î
Apply a continuous
bead of silicone
sealant to the
nailing-in flanges
8
Kohler Co.
Publicidad
