Elvox 170F Manual De Instrucciones página 7

MUTUALLY EXCLUSIVE MODE
In this mode only one output is activated at a time. When a valid command is sent (one of the memorised commands), the out-
put active at the time is deactivated and the new one is activated. The panel call command (with or without camera, following
audio or video self-start) together with the reset command, deactivate any enabled output. After an entrance panel call, no
memorised command can activate any of the outputs until a reset command is sent. The only exception is the reception of a
valid command with the same number as the last call made from the entrance panel.
To activate this operating mode, see the next paragraph
OPERATING MODE CHANGE PROCEDURE:
Any loads connected to the outputs should be disconnected before programming to avoid inadvertent activations.
This procedure enables the user to change from the Basic operating mode to Mutually Exclusive mode and vice versa.
. Press RES and the key P1 at the same time.
. Release the RES key while keeping key P1 pressed
. Press and hold P1 for at least 10 seconds until leds S2 and A illuminate.
. On release of key P1 the four leds start to flash in pairs (S1 with B and S2 with A).
. To change the operating mode press P1 again and hold for approx. 3 seconds.
Correct programming is confirmed when during the 3-second interval that P1 is pressed only one pair of leds remains lit and at
the end of the procedure all leds switch on briefly and then all turn off. If this procedure is not performed correctly all leds turn
off immediately and the device continues to operate as normal.
PROCEDURE FOR THE CONNECTION TO THE "PC DIGIBUS ANALYSER" SOFTWARE
Install the software "PC Digibus Analyser" freely loadable from the Elvox Site in the following link:
http://www.elvox.it/~elvoxftp/Elvox_Software_Digibus.htmi.
Connect the device through the serial interface 6952 or USB 6952/A according to the following figure and table:
Terminals 6952 or 6952/A
-
TX
*
the connection to the PC operates only if the digital line is connected to terminal 6
Start the program, select the COM of PC where the interface is connected, select then baud rate "1200" and click "Configura
Principali Parametri" (Configure main Parameters).
Follow the monitor instructions to be able to read and/or modify the device parameters.
Led RX lit if the connection is OK!
Terminal 170F
4
6*
NOTE: Avoid connecting in parallel
other digital devices on this connec-
tion.
TX + RX
GND
Jumper up
Device
170F