BMV 5 Serie Manual Del Usuario página 63

Connect branch A2, white 12-pin socket housing from on-board monitor wiring harness A, to white 12-pin
pin housing (49) at on-board monitor (9).
Now fit the cables into on-board monitor compartment (50) and carefully insert on-board monitor (9).
Make sure when inserting the on-board monitor that no cables are damaged.
Fig. D
Firmly secure on-board monitor (9) to on-board function unit carrier (11) with four M3x8 cross recessed cheese head
screws (12).
Now fit finisher for on-board monitor (13) into retaining lugs of function unit carrier for on-board monitor (11) and
firmly secure to on-board monitor (9) with two M3x8 cross recessed cheese head screws (12).
Fig. E
Figure shows rear left of luggage compartment
Fit GPS receiver (19) on threaded stud (51) of mounting bracket for DSP amplifier and GPS receiver (15) and secure
with two plastic cap nuts (27).
Fit M5 speed nut (24) on mounting bracket for DSP amplifier and GPS receiver (15).
Connect branch B4, black 12-pin socket housing from navigation wiring harness B, to black 12-pin pin housing (52)
at GPS receiver (19) (for further routing of navigation wiring harness B refer to Section 2.6).
Connect branch E2, coaxial socket housing of antenna extension for GPS antenna E, to coaxial pin housing (53)
at GPS receiver (19) and route the antenna extension for GPS antenna E through the leadthrough grommet behind
the rear seat backrest along the audio wiring harness (see Fig. A) to place of installation of GPS antenna under the
rear window shelf and secure with cable straps (32).
Finally fit two 4.8 plastic expanding nuts (26) in cross brace (54) in rear left side section.
Fig. F
Fit mounting bracket for DSP amplifier and GPS receiver (15) with mounted GPS receiver (19) on retaining stud (55)
in rear left side section and firmly secure with two 4.8x16 hexagon self-tapping screws with washers (25).
Fit 4.8 plastic expanding nut (26) in rear left frame section.
Fig. G
Adhere sealing strip (34) on basic carrier (16).
Fit five M5 speed nuts (24) on basic carrier (16) and firmly secure basic carrier (16) to rear left of luggage
compartment floor with two plastic cap nuts (27) and one 4.8x16 hexagon self-tapping screw with washer (25).
Now fit two rubber grommets (28) in the recesses provided in the mounting bracket for DSP amplifier and GPS
receiver (15) as well as in basic carrier (16).
Firmly secure mounting bracket for front video module (17) to basic carrier (16) with two M5x12 hexagon screws with
washer (23) and to retaining stud (55) with one plastic cap nut (27).
Fig. H
Slide on-board monitor radio (14) into previously fitted rubber grommets (28).
Fit mounting bracket for on-board monitor radio and CD changer (18) and firmly secure to basic carrier (15) with
three M5x12 hexagon screws with washers (23).
Depending on the version, firmly secure on-board monitor radio (14) to mounting bracket for on-board monitor radio
and CD changer (18) with M5 hexagon nut and washer (22) or with M5x12 hexagon screw and washer (23).
Remove blue locking clip (56) from black 17-pin socket housing A13 and connect branch A14, 10-pin socket
housing from on-board monitor wiring harness A, to point provided in black 17-pin socket housing A13.
The on-board monitor radio/CD changer control line must be additionally installed on vehicles with
CD changer and without DSP amplifier.
Lock branch A14, 10-pin socket housing, with blue locking clip (56).
2-50