Blade Assembly; Switch Housing Plate Assembly - Craftmade Mia Guia De Instalacion

8. Blade Assembly.

WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws/washers in
hardware pack. Hold blade arm up to blade and
align holes. Insert 3 blade attachment
screws/washers with fingers first and then tighten
screws securely with a Phillips screwdriver. Repeat
for the remaining blades.
Remove blade arm screws/lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade
arm with blade arm screws/lock washers. Before
securing screws permanently, repeat with
remaining blade arms. Securely tighten all screws.
NOTE: Tighten blade arm screws twice a year.
9. Switch Housing Plate Installation.
Remove screw (with the RED DOT) from the fitter
plate on underside of motor (save screw for later
use); partially loosen the other 2 screws.
Align slotted holes in switch housing plate with
loosened screws in fitter plate, allowing male plug
from motor housing to come through hole in
middle of switch housing plate. Twist switch
housing plate to lock. Re-insert screw that was
previously removed and securely tighten all 3
screws with Phillips screwdriver.
If you wish to use fan WITH the light kit, proceed
to Section 11 on following page.
plastic
motor
lock
male
plug
switch
housing
plate
page 7
motor housing
blade attachment
screws and washers
blade arm
blade arm screws/
lock washers
motor housing
fitter
plate
red
dots
blade