Kohler K-T194 Guia De Instalacion página 3

Setscrew
Spout
Shank
1. Install the Spout
IMPORTANT! Use care when installing the spout to avoid
scratching the finish.
Remove the spout thread protector and discard it.
Slide the bonnet onto the spout.
Loosen the spout setscrew, and thread the spout into the mixer
outlet port until it is snug.
Back off the spout until it faces straight down. Tighten the
setscrew.
Carefully slide the bonnet onto the spout, pushing firmly until it
contacts the spout shank flange.
Apply plumbers putty or other sealant to the back surface of the
spout escutcheon according to the putty manufacturer's
instructions.
Carefully slide the escutcheon over the spout and bonnet, and
press it firmly against the wall.
Remove any excess putty or sealant.
Kohler Co.
Spout
Thread
Protector
Spout
Mixer
Outlet Bonnet
Port
Apply
plumbers
putty.
Escutcheon
3 1016743-2-B