Handle Installation - Uline H-4564 Manual Del Usuario

III. HANDLE INSTALLATION
1. Remove handle from protective
wrapping.
2. Loosen set screw (140) on crank link
(139H). (See Figure 7)
Figure 7
(139H)
Set Screw
(140)
3. Remove 3 hex screws (H109) and 3
spring washers (H110) from bottom of
handle.
4. Feed Wire, Chain and Pin (H107) on
bottom of handle through center of
base (103) and axle (109). (See Figure 8)
Figure 8
8 OF 62
ASSEMBLY INSTRUCTIONS CONTINUED
H107
103
Axle
(109)
5. Attach handle to base (103) using 3
hex screws (H109) and 3 spring washers
(H110) and tighten with Hex Wrench
provided. (See Figure 9)
Figure 9
6. While raising crank link (139H), slide pin
of rod and chain (H107) into crank link
groove. (See Figure 10)
Figure 10
REFERENCE PARTS DIAGRAMS
PAGES 16-19
Hex Screw
(H109)
Spring
Washer
(H110)
(103)
Crank Link
(139H)
H107
0721 IH-4564