Jacuzzi energy Uso Y Mantenimiento página 11

not been completed and that the tank is empty (in any case, when
pressing the key, the alarm signal is interrupted).
The display does not receive commands
- If two keys are accidentally pressed at the same time, no fun-
ction is activated.
You will need to wait three seconds before giving a new command
- If the display is covered by a layer of water, it may not receive
commands.
Just wipe the water off with the palm of your hand and wait about
3 seconds before giving another command.
MAINTENANCE
ATTENTION! Before carrying out any maintenance op-
eration, disconnect the appliance from the power sup-
ply line.
Cleaning the air outlets
Remove any residue and wash the various components with wa-
ter and soap.
Cleaning the hydromassage outlets
Proceed as described above.
Cleaning the tub and the taps and fittings
Use non-abrasive or powder detergents (pay attention to the
writing on buttons).
Do not use acetone or other solvents.
Cleaning the headrest
Use a cloth or a soft brush and soap.
11 11