Assembly - Bissell POWERTRAK 2598 Serie Guia Del Usuario

Assembly

WARNING
Do not plug in your vacuum until you are familiar with all instructions and operating procedures.
1
Install the Upper Cord
Wrap by aligning tabs and
pushing down until you
hear a "click".
4
With the Quick Release
Lever in upright position -
slide handle into base and
push the lever down to lock
handle into place.
7
Wrap power cord
around the cord wraps.
NOTICE
» Brush Roll continues to turn while product is turned on and handle is in upright position. To avoid
damage to carpet, rugs furniture and flooring, avoid tipping vacuum or setting it on furniture, fringed
area rugs, or carpeted stairs during tool use.
» With Brush Roll on, do not allow cleaner to sit in one location for an extended period of time, as
damage to floor can result.
2
Push Lower Cord Wrap
in, aligning two tabs, then
turn clockwise (down) to
lock into place.
5
Insert the end of the hose
into the hose connector
at the foot base inlet
opening.
8
3
Install the Wand Release
Clip by aligning tabs and
pushing down until you
hear a "click".
6
Wrap the hose around the
upper hose clip.
Snap the TurboBrush®
Tool Clip to the handle.
Line up base of the
TurboBrush to bottom
of tool holder and push
gently into place to
secure.
Store Combination
Dusting/Upholstery
Tool on the storage
post located on the
back of the vacuum.
5