Assa Abloy Code Handle Window Instrucciones De Montaje página 5

Operating Instructions Code Handle
Operation - unlocking/locking
Once the Code Handle has been programmed, the
handle can be operated.
1. To unlock, enter a valid user code.
2. To lock, press the lock button.
The handle must be in the 0°,90° or 180° position in
order to lock or unlock.
5
Enter/change user codes
1 2 3 4
Apart from the administrator code the Code Handle
Window can store 4 additional user codes.
The factory administration code must be changed
before a new user code can be added.
a. Before you start, write down the user code on page
2 (6 digits).
b. Hold the lock button pressed to enter program-
ming mode. The LED turns steady green.
c. Enter the administrator code. The LED turns steady
green.
d. Press button 1 to select programming of user
codes. The LED turns steady green.
e. Select one of the 4 memory positions by pressing
the corresponding button, 1-4. The LED turns
steady green.
f. Enter the new user code (6 digits). The LED flashes
green.
g. Test the new code by locking and unlocking.
To store additional codes in the remaining memory
positions, repeat the steps above.
6 Audio signal
The code handle is delivered with the audio signal
enabled. To turn it off/on do the following:
a. Hold the lock button pressed to enter program-
ming mode. The LED turns steady green.
b. Enter the administrator code. The LED turns steady
green.
c. Press pushbutton 2 to turn the audio signal off/on.
The LED flashes green with a beep (audio signals
on) or without a beep (audio signals off).
Window
®
7 Erase user codes
a. Hold the lock button pressed to enter program-
ming mode. The LED turns steady green.
b. Enter the administrator code. The LED turns steady
green.
c. Press button 4 to select programming of user
codes. The LED turns steady green.
d. Select which one of the 4 memory positions to be
erased by pressing the corresponding button, 1-4.
The LED turns steady green.
e. Press the lock button to erase the user code. The
LED flashes green.
Reset / change administrator code
If you change the the administrator code, the handle
will also be reset (audio signal enabled and additional
user codes erased).
See section "3 Enter/change administrator code" above
for instructions.
Lost codes
A new user code can be entered using the administra-
tor code, see section "5 Enter/Change user code" above.
If the administrator code is lost, you will not be
able to re-program the handle!
Security
If an incorrect code is entered five times consecuti-
vely, the code handle will be disabled for 3 minutes
and cannot be opened during this time. The purpose
is to prevent unauthorized people from opening the
handle. The LED flashes red and the handle beeps
repeatedly during this time.
Batteries & battery warnings
A battery warning is given when the battery capacity
is reduced to a minimum. The LED flashes red along
with a beep every time a button is pressed, to indicate
the need to replace the batteries. In addition, after
entering a correct code, the LED flashes red along with
a beep five times to accentuate the need to replace
the batteries.
Battery lifetime depends upon several parameters
such as battery quality, frequency of operation for
example. With normal usage the batteries will last
for several years. The product is supplied with GP
branded batteries. It is recommended to use batteries
of a well-known brand for best performance.
If the battery capacity is below minimum, the handle
will not respond at all.
5