Publicidad
Idiomas disponibles
Idiomas disponibles
1. Lower one or more of the passenger windows so the keys do not get locked in the ve-
hicle.
2. Disconnect and isolate the negative battery cable. The battery will need to be re-connected before
programming.
3. Locate and cut provided new keys prior to remote start installation.
TOOLS REQUIRED
KIT CONTENTS
1X
2X
2X
This instructional manual will discuss the installation of the hood switch harness & XBM (Remote
Start) turn-on. Other steps will include replacement procedure of the WCM, antenna installation,
hood switch installation, and uploading of vehicle configuration from Dealer Connect. Refer to the
vehicle Service Manual for specific installation procedures for all components except the hood
switch harness, which is covered here in detail.
Hood Switch and Striker Plate Installation
1. Refer to the vehicle Service Manual section 8
Electrical/Vehicle Theft Security/Hood Ajar Switch/
Installation - for Hood Switch installation. Note: Use
a nut-rivet tool appropriate for a M6 X 1.00 nut-rivet.
Disconnect Ground From Battery
1. Remove ground from battery
a. Using a 10 mm socket, remove the negative battery cable.
VEHICLE PREPARATION
12X
1X
2X
2X
Installation Procedure:
10mm
1/4"
1X
2X
OVERVIEW
2 of 9
T-20
1X
1X
1X
Publicidad
