Kohler K-712 Manual Del Usuario página 18

Ocultar thumbs Ver también para K-712:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Test Run the Bath with Airjets (cont.)
Confirm the Surge Mode Operation
NOTE: The surge mode cycles the speed of the blower motor between minimum and maximum settings,
as shown on the indicator bar on the user keypad. Six cycle times are available, ranging from about 10
seconds to about one minute. In this mode, the cycle time can be controlled using the up or down button
on the user keypad. The surge mode will operate with any zone or all zones selected.
Select and activate the surge mode.
Verify that the air flow cycles between minimum and maximum.
Increase or decrease the speed of the surge cycle by pressing the up or down button.
Press the power button on the user keypad.
Operate the Chromatherapy Cycle (if equipped)
Rotate the outer ring to the chromatherapy icon, then press "OK". The chromatherapy lights will
automatically and continuously cycle through the eight colors; white, violet, indigo blue, aqua blue,
green, yellow, orange and red. One cycle through all eight colors takes approximately one minute.
Press "OK" while the chromatherapy mode is active to turn off the chromatherapy lights.
Rotate the outer ring to the chromatherapy specific color icon, then press "OK". Use the up or down
arrows to reach the desired color.
Press "OK" again to turn off the chromatherapy lights.
Operate the Automatic Purge Cycle
NOTE: The automatic purge cycle occurs after the bath is drained. It operates at low speed for about two
minutes to remove any residual water from the air harness.
If required, fill the bath to a level at least 2" (5.1 cm) above the top of the highest airjet.
Drain the bath.
When the water level drops below the level sensor probes, verify that the blower starts at low
speed.
After about two minutes, verify that the blower motor stops.
Operate the Manual Purge Cycle
With the bath drained, rotate the outer ring to the purge cycle icon.
Press the "OK" icon.
Observe that the blower starts in the purge cycle. Residual water will blow out from the air harness.
After the blower has operated for about two minutes, observe that the blower stops.
Place the protective drop cloth over the bath.
Turn off the power to the bath.
1146828-2-A
18
Kohler Co.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-809K-852K-856K-865

Tabla de contenido