Getting Started; Connecting The Magnification Feature Pack To The Optelec Clearreader; Turning-On The Clearreader - Optelec ClearReader+ Manual Del Usuario

Optelec
3.

Getting Started

3.1

Connecting the Magnification Feature Pack to the Optelec ClearReader

Connect the Magnification Feature Pack to the ClearReader
the VGA connector at the bottom rear side of the ClearReader
visible, you will need to remove the protection cover which will also reveal two USB connectors.
Use a Philips screwdriver to remove the screw which closes the cover. This screw is located in
the middle of the bottom side of the ClearReader
using a VGA cable. Adjacent to the VGA connector there are two USB ports. Connect the USB
cable of the ClearReader
side or to the USB port on the right side of the unit.
When the Magnification Feature Pack is connected to the ClearReader
snapshot of a document as described in the ClearReader
3.2

Turning-on the ClearReader

To switch-on, press the round Power button on the right-hand
side of the ClearReader
approximately 40 seconds. You will hear a series of beeps to
indicate that the ClearReader
start-up sound. Now the Power indicator on the top side of the
unit beneath the volume dial is lit up and the ClearReader
ready to use.
English
+
Magnification Feature Pack to one of the two USB ports on the rear
+
+
. The start-up process will take
+
is starting up followed by the
+
and optionally, a monitor. Locate
+
. If the VGA connector is not
+
. Connect the monitor to the ClearReader
+
user manual.
+
is
ClearReader
+
+
, switch-on and take a
Page 8
+
+
by