Hunter The SUMMER BREEZE Serie Guia Del Propietario página 5

LINE Cord SaFETy TIpS
1. NEVEr pull or yank on the cord
or the appliance.
2. To insert plug, grasp it firmly
and guide it into the outlet.
3. To disconnect the appliance,
grasp the plug and remove it
from the outlet.
4. Before each use, inspect the line
cord for cuts and/or abrasion
marks. If any are found, the ap-
pliance should be serviced and
the line cord replaced. please
return it to our Service depart-
ment or to an authorized service
representative.
5. NEVEr wrap the cord tightly
around the appliance, as this
could place undue stress on the
cord where it enters the appli-
ance and could cause it to fray
and break.
6. do NoT operate appliance if
the line cord shows any dam-
age, if the appliance works
intermittently or stops working
entirely.
7. do NoT use an extension cord
with this fan.
42733-01 04/26/2007
clockwise into the Cast Iron 1. - s coping p Support Cap, making sure the p t he Cast Iron Base. Twist the Telescoping pole clockwise to secure it into the Cast Iron Base. - b ly over so it rests on the floor. installed, tagged) in the neck of Cast Iron Base underneath the Base Cover. See Figures 1 and 2. Base until it is tight. See Figure
NoTE: assembly of this fan will
be easier if performed by two
people.
1. Lower the Base Cover over the
Cast Iron Base. See Figure 1.
FIGurE 1
aSSEMBLy
Telescoping pole
Cover Support Cap
Base Cover
pole Setscrew
(pre-installed,
tagged)
Cast
Iron
Base
5