Programming; Audio Level Adjustment - Axxess AXGMMT-02 Instrucciones De Instalación

Attention! If the interface loses power for any reason, the following steps will need to be performed again. Also, if installing an
AXSWC, connect it after you initialize and test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note: If the radio doesn't come on within 60 seconds, turn the key to the off position, disconnect the interface, check all
connections, reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions of the installation for proper operation,
before reassembling the dash.

AUDIO LEVEL ADJUSTMENT

• With the vehicle and radio turned on, turn the volume up 3/4 of the way.
• Locate the end of the AXGMMT-02, where the 16-pin harness with stripped leads connects to.
• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio level; counterclockwise to lower the
audio level.
• Once at a desired level, audio level adjustment is complete.
AxxessInterfaces.com

PROGRAMMING

© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
AXGMMT-02
I N S TA L L AT I O N I N S T R U C T I O N S
Having difficulties? We're here to help.
Contact our Tech Support line at:
386-257-1187
Or via email at:
techsupport@metra-autosound.com
Tech Support Hours (Eastern Standard Time)
Monday - Friday: 9:00 AM - 7:00 PM
Saturday: 10:00 AM - 7:00 PM
Sunday: 10:00 AM - 4:00 PM
K
®
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
REV. 5/26/20 INSTAXGMMT-02
P
OWER