Mma Welding; Mig/Mag Welding - Migatronic SIGMA SELECT BASIC Guía Rápida

1
5
8 9
2
6
7
11A
10 11
13
A B
14
1. Welding current, [A]
2. Wire feed speed, [m/min]
3. Welding voltage, [V]
4. Arc adjust
5. Lock symbol
Lock: Insert the SD lock card.
Unlock: Reinsert the SD lock card to unlock.
6. Warning – Overheating
7. Fault indicator
See instruction manual
8. Display of wire feed speed or
welding current
9. Display of welding voltage or
Arc adjust
10. Setting wire feed speed or
welding current
Turn the control knob to set the desired
3
wire feed speed (MIG/MAG) (see table 1) or
4
welding current (MMA).
11. Setting welding voltage,
Arc adjust and welding process
Turn the control knob to set the desired
welding voltage or Arc adjust (see table 1).
Short press (11A) (MIG/MAG): Change
between display of welding voltage and Arc
adjust.
12
Long press (11A): Opens for setting the
welding process (see figure 1).
12. Selecting trigger mode
Change between 2-stroke (indicator off) and
4-stroke (indicator on).
2-stroke: The welding process starts when
the torch trigger is activated and ends when
the torch trigger is released.
4-stroke: The welding process starts when
the torch trigger is activated and released
and ends when the torch trigger is activated
again.
Long press: Opens user menu. For detail
information, see instruction manual.

13. MMA welding

Press the key to choose MMA welding.
Long press recalls factory settings if indicator
is on.

14. MIG/MAG welding

Press the key to choose MIG/MAG welding
(14A = CO / 14B = Mix).
2
Long press recalls factory settings if indicator
is on.
For more information, please refer to the
welding table.
15. Wire inching
Press the key to feed the wire and adjust
the wire feed speed by turning (10)
simultaneously.
Sigma Select C
15
Sigma Select S
15 15
QUICKGUIDE
SIGMA SELECT BASIC