En - General Instructions For Installation; Important Safety Information - Stell SHO 5000 Manual Del Usuario

EN – GENERAL INSTRUCTIONS FOR INSTALLATION

IMPORTANT SAFETY INFORMATION

• Check the content of the package in parts list on page 2 and make sure that all parts are in
order. Do not use damaged or faulty parts.
• Read all instructions before installing the equipment. When you are unsure about any part of
the installation process, ask a professional technician for help.
• When tightening the screws, be careful to avoid stripping the thread.
• Do not install on a damp or otherwise damaged wall. The assembly material supplied in the
package is designed to be mounted on a wall of bricks and concrete. For installation on walls
made of other materials consult a professional.
• Never install or use this product if there are signs of damage.
• The edges of the equipment may cause injury if they are handled improperly.
• This device is not designed for assembly or handling by small children, or persons, who have
not been specifically instructed unless supervised by a responsible person to ensure safety
during handling or installation. Children should be supervised to ensure that they do not
interfere with the equipment. Do not allow children to hang on the equipment or otherwise
handle it. Otherwise, there is a danger of serious injury. Never insert your fingers or other
objects into the mechanism of the equipment. It could cause personal injuries or property
damage.
• The product contains small parts that can pose a choking hazard when inhaled or swallowed.
Keep these parts out of reach of children!
Note: Specifications and design are subject to change due to improvements without notice.
LIST OF SUPPLIED PARTS
Holder body
A
Cover of the holder body
B
Swivel joint
C
Speaker base
D
Screw M8×60
E
INSTALLATION
Attachment of the holder body to the wall made of bricks or concrete or a panel
Mark the position of 3 holes on the wall for attaching the body of the holder. Use the body
as a template (Fig. 1). Pre-drill holes in the wall at least 5 cm deep using a drill (8 mm) and insert
a plastic anchor in each hole
with the wall.
Installing the audio cables
If the input audio cables are installed inside the wall, insert them prior to the attachment of the
holder into the back of the holder body and after putting on the plastic cover pull them out of the
designated hole, see Figure 8.
In case that the cables are routed along the wall, insert them after the installation of the holder
in a designated hole and then bring them out through a designated hole according to Figure 9.
Plastic washer
F
Washer M8
G
Nut M8
H
Wood screw M4×12
I
Screw M6×45
J
. Make sure that the plastic anchor is entirely inserted and level
L
12 – EN
Washer under the screw
K
Plastic anchor M8×40
L
Key
M
A