Stell SHO 5000 Manual Del Usuario página 13

(Fig. 2). After attaching
Then attach the holder to the wall using three screws and washers
J K
(Fig. 3).
the holder body put the cover on it
B
Assembly of the holder and installation of the speaker
Assemble the holder according to the instructions in Figure 4. Insert the swivel joint on the end of
the holder body . Insert in the joint the base of the speaker and attach it using the screw and
C E
the plastic washer and fasten it using the nut and the washer .
F H G
Then place the speaker on the holder. Set span (in the range 137-280 mm) of the fastening clamps
so that the speaker is held tightly in place. Tighten the clamps using the a screwdriver (Fig. 5).
(Fig. 6).
You can secure the speaker additionally using five wood screws
I
Adjusting the tilt and rotation of the speaker
You can rotate the speaker in the holder horizontally 360° and tilt it 7,5° vertically up and down.
Release the nut using the supplied key , perform the required position adjustment and tighten
M
the nut again (Fig. 7).
Congratulation, the installation is done. We wish you a pleasant experience while listening to
a speaker attached using this holder.
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING
Take the used packaging material to the municipal waste disposal.
PRODUCT DISPOSAL AFTER END OF LIFE
Dispose of equipment after the end of life in the designated municipal solid waste place
This product meets all the basic requirements of EU directives that apply to it.
13 – EN