Double DIN radio provision
1. Cut and remove the center bar
from the radio housing. (Figure A)
2. Snap the Double DIN brackets
to the inside edge of the radio/
climate housing panel. (Figure B)
3. Slide the radio into the radio/
climate housing panel assembly
and secure to the assembly using
screws supplied with the radio.
(Figure C)
4. Snap the double DIN trim plate
into the radio/climate housing
panel. (Figure C)
5. Connect the climate extension
harness to the climate control
harness removed in step 12 of
disassembly, and then into the
radio/climate housing panel.
Kit Assembly
6. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-
connect the negative battery
terminal and test the unit for
proper operation.
7. Reassemble the dash in reverse
order of disassembly, using the
radio/climate housing panel
instead.
(Figure A)
®
99-5721
(Figure B)
(Figure C)
6