Intended Use; Safety Notes - Valentin ILX 56/8 Guía De Referencia Rápida

ILX

Intended Use

•
The printing system is a state-of-the-art device which complies with the recognized safety-related rules and regulations.
Despite this, a danger to life and limb of the user or third parties could arise and the printing system or other property co uld
be damaged while operating the device.
•
The printing system may only be used while in proper working order and for the intended purpose. Users must be safe,
aware of potential dangers and must comply with the operating instructions. Faults, in particular those which affect safety,
must be remedied immediately.
•
The printing system is solely intended to print suitable media which have been approved by the manufacturer. Any other or
additional use is not intended. The manufacturer/supplier is not liable for damage resulting from misuse. Any misuse is at
your own risk.
•
Intended used includes heeding the operating manual, including the maintenance recommendations/regulations specified
by the manufacturer.

Safety Notes

•
The printing system is designed for power supply systems of 110 ... 230 V AC. Connect the printing system only to
electrical outlets with a ground contact.
•
Couple the printing system to devices using extra low voltage only.
•
Before making or undoing connections, switch off all devices involved (computer, printer, accessories etc.).
•
Operate the printing system in a dry environment only and do not get it wet (sprayed water, mist etc.).
•
Do not operate the printing system in explosive atmosphere and not in proximity of high voltage power lines.
•
Operate the printing system only in an environment protected against abrasive dust, swarf and other similar impurity.
•
Maintenance and servicing work can only be carried out by trained personnel.
•
Operating personnel must be trained by the operator on the basis of the operating manual.
•
If the printing system is operated with the cover open, ensure that clothing, hair, jewellery and similar personal items do not
contact the exposed rotating parts.
NOTICE!
With the open printing unit (due to construction) the requirements of EN 62368-1 regarding fire protection casing
are not fulfilled. These must be ensured by the installation into the end device.
•
The print unit and parts of it (e.g. motor, printhead) can get hot during printing. Do not touch the printhead during operation.
Cool down the print unit before changing material, removal or adjustment.
•
Never use highly inflammable consumables.
•
Carry out only the actions described in these operating instructions. Any work beyond this may only be performed by the
manufacturer or upon agreement with the manufacturer.
•
Unauthorized interference with electronic modules or their software can cause malfunctions.
•
Other unauthorized work or modifications to the printing system can endanger operational safety.
•
Always have service work done in a qualified workshop, where the personnel have the technical knowledge and tools
required to do the necessary work.
•
There are warning stickers on the printing system that draw your attention to dangers. Therefore the warning stickers are
not to be removed as then you and others cannot be aware of dangers and may be injured.
•
Before installing the printing module in the system, the commissioning engineer must ensure that the statutory safety
regulations are observed and the necessary safety devices are installed.
NOTICE!
When mounting an optional label applicator, the applicable safety regulations must be observed.
•
All isolating safety equipment must be installed before starting-up the printing system.
104 English