Filter Cartridge Replacement - Du Pont WFHD13001 Serie Instrucciones De Instalación

Filter Cartridge Replacement

STEP 1
1
Turn off the main water supply to your home.
NOTE: This will shut off all water flow in the home.
2
Purge all water from the plumbing lines by turning on all faucets in your home and draining completely.
3
Press the red pressure-relief button on top of the Filter System
4
Use the Filter Housing Wrench
NOTE: Use a pan or bucket to catch any water in the Filter Housing.
Pour out the water in the Filter Housing and remove the used Filter Cartridge
STEP 2
NOTE: Have a pan or bucket handy to rinse out the Filter Housing.
1
Rinse out the bottom of the Filter Housing.
2
dd enough water to fill the Filter Housing 1/3 full. dd approximately 2 tablespoons of bleach and clean the System Head and
bottom of the Filter Housing with a clean cloth.
3
Rinse the Filter Housing thoroughly to remove bleach.
4 B
Remove the O-Ring in the top of the Filter Housing and wipe clean.
Use silicone grease to lubricate the O-Ring.
6
Place the O-Ring back in the groove of the Filter Housing.
NOTE: Make sure that the O-Ring is seated properly in the groove to ensure a good seal.
STEP 3
1
Insert the new Filter Cartridge over the standpipe in the bottom of the Filter Housing.
2
Screw the Filter Housing back onto the System Head and hand-tighten. Using the Filter Housing Wrench, tighten 1/4 turn.
NOTE: Do not over tighten.
3
Slowly turn on the water supply at the main shutoff valve.
4
Press the red pressure-relief button on top of the Filter System to release any trapped air.
Check for any leaks before proceeding. (Refer to troubleshooting on Page 6.)
6
Turn on the nearest faucet and flush the Filter System for 40 minutes.
WFHD13001 Series
to release pressure.
D
to unscrew the Filter Housing.
C
.
7
1
3
4
D
B
C
4
V4.0