Ezviz LC1C Guia De Inicio Rapido página 7

Step 3
Separate the mounting bracket from the security light camera.
1. Unscrew the 2 base screw caps.
2. Pull the security light camera off the mounting bracket, and
unplug the wire connector from the bracket.
Mounting Bracket
Wire Connector
Step 4
Install the mounting bracket.
• When installing the mounting bracket, make sure the logo (UP) faces upward.
• Make sure the wall/ceiling is strong enough to withstand three times the weight of the security light camera.
The security light camera can be mounted on the wall or ceiling. Here we take wall mounting as an example.
1. Pick a clean and flat surface.
2. Drill two holes on the wall and insert anchors.
3. Take the wires from the wall through the rubber of the mounting bracket.
4. Fix the mounting bracket to the wall with mounting screws.
Anchor
Step 5
Connect the wires.
Follow the steps to connect the wires from your wall to the wires on your security camera, as shown in the figure below.
1. Attach the ground (or yellow-green) wire from your wall to the yellow-green wire on your security light camera.
2. Attach the hot (or brown) and neutral (or blue) wires from your wall to the brown and blue wires on your security light camera respectively.
3. Secure them using screwdriver (sold separately).
Base Screw Cap
Mounting screw
3. After separating the mounting bracket from the camera, the
resulting picture is shown as below.
Mounting Posts
Keep the mounting posts stay in the bracket.
3
UP