Publicidad
3.
Drill pilot holes using a 3 mm (1/8 in.) diameter drill bit.
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 63.5 mm (2½ in.).
01
4.
Install the wall plate
Tighten the lag bolt only until it is pulled firmly against the washer. Tighten screw only until it is pulled firmly against the wall plate.
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts or screws.
3
3 mm
(1/8 in.)
03
using the lag bolt
and the washer
04
. Secure the bottom of the wall plate using the #8 screw
4
02
04
03
01
02
.
9
Publicidad
