Fan Speed - Aircare 5D6700 Guía De Uso Y Cuidado

NOTE: We recommend using Essick Air
the water reservoir to eliminate bacterial growth. Add bacteriostat according to the
instructions on the bottle. Under no circumstances should you use Water
Treatment products intended for Rotobelt or Ultrasonic humidifiers.
ABOUT HUMIDITY
Where you set your desired humidity levels depends on your personal comfort
level, the outside temperature and the inside temperature.
NOTE: Recent CDC tests show that the chances of flu transmission are greatly
reduced at levels of 43% humidity.
You may wish to purchase a hygrometer* to measure the humidity level in your
home. Following is a chart of recommended humidity settings.
IMPORTANT: Water damage
may result if condensation
starts to form on windows or
walls. Humidity SET point
should be lowered until
condensation no longer forms.
We recommend room humidity
levels do not exceed 50%.
*A digital hygrometer is available for purchase by calling 1-800-547-3888.
NOTE: External hygrometer readings and humidistat readings may differ. Humidity
levels can vary significantly even in one room. The amount of time it takes to affect
the room humidity depends on the relative humidity of the air. In especially dry areas
it could take up to 48 hours to see humidity climb to the desired level.
OPERATION
Plug cord into wall receptacle. Your humidifier is now ready for use. The humidifier
should be placed at least FOUR inches away from any walls and away from heat
registers. Unrestricted airflow into the unit will result in the best efficiency and
performance.
NOTE: This unit has an automatic humidistat located on the cord that senses the
humidity level around the immediate area of the humidifier. It turns the humidifier on
when the relative humidity in your home is below the humidistat setting and will turn
the humidifier off when the relative humidity reaches the humidistat setting.
®
Bacteriostat Treatment when you refill
When Outdoor
Temperature is:
°F
-20 -30°
-10° -24°
2° -18°
10° -12°
20° -6°
30° -1°
CONTROL PANEL
TO TURN ON/OFF
For initial operation, plug the unit in
(the display will show - -). Press the
button to turn the unit on or off.

FAN SPEED

The 5D6700 has a four speed digital
control panel.
1) Press the
fan speeds.
2) The speeds: High (F4) - Low (F1)
display on the digital panel. A
display of "00" indicates the fan is
in standby and can be adjusted as
desired.
5
Recommended
Indoor Relative
° C Humidity (RH) is
15 - 20%
20 - 25%
25 - 30%
30 - 35%
35 - 40%
40 - 45%
button to adjust the