Wiring Instructions - Metra 99-7612A Instrucciones De Instalación Para La Pieza

Kit Assembly
ISO DDIN radio provision (continued)
4. Mount the climate module to the
radio/bracket assembly using (2)
3/8" Phillips screws supplied with
the kit. (Figure D)
5. Plug the white flat 16-pin
connector, removed in
disassembly, into the 99-7612.
6. Mount the radio/climate assembly
to the radio trim panel using (4)
3/8" Phillips screws supplied with
the kit. (Figure E)
7. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
8. Follow the wiring instructions in
this manual and reassemble dash
in reverse order of disassembly.
(Figure D)
(Figure E)
®
99-7612

Wiring Instructions

From the included 7612 harness:
1. Plug the Black 16-way connector
into the 99-7612.
2. Plug the Black 12-way connector
into the 99-7612.
3. Plug the White 16-way connector
into the factory harness.
Driver Information Center
Button Control Note:
The Metra kit button layout
does not provide the MAINT or
the E/M buttons from the factory
setup. MAINT button on the 99-7612 is
accessed by pressing the DAY/NIGHT
and HOUR buttons simultaneously.
The E/M button is done by pressing
PREV and MIN simultaneously.
5
Additional 12-pin harness (ASWC-1)
• This 12-pin harness is to be
used in conjunction with the
ASWC-1 (not included). Please
refer to the ASWC-1 instructions
for programming.