Troubleshooting Chart - Cub Cadet CC4105 Manual Del Operador

ENGINE WILL NOT START
C A U S E
Empty fuel tank
Primer bulb wasn't pressed enough
Old fuel
Fouled spark plug
Plugged spark arrestor
When it is above 40°F outside & the Cold Weather Start Lever
is in the CLOSED / START position
When it is below 40°F outside & the Cold Weather Start Lever
is in the RUN / OPEN position
ENGINE WILL NOT IDLE
C A U S E
Air filter is plugged
Old fuel
Improper carburetor adjustment
ENGINE WILL NOT ACCELERATE
C A U S E
Old fuel
Improper carburetor adjustment
Cutting attachment bound with grass
Dirty air filter
Plugged spark arrestor
ENGINE LACKS POWER OR STALLS WHEN CUTTING
C A U S E
Old fuel
Improper carburetor adjustment
Fouled spark plug
Plugged spark arrestor
CUTTING ATTACHMENT WILL NOT ADVANCE LINE
C A U S E
Cutting attachment bound with grass
Cutting attachment out of line
Inner reel bound up
Cutting head dirty
Line welded
Line twisted when refilled
Not enough line is exposed
CUTTING LINE ADVANCES UNCONTROLLABLY
C A U SE
Oil, cleaner or lubricant in cutting head
If further assistance is required, contact your authorized service dealer.
TROUBLESHOOTING
A C T I O N
Fill fuel tank with fuel
Press primer bulb fully and slowly 10 times
Drain gas tank and add fresh fuel
Replace or clean the spark plug
Clean or replace spark arrestor
Flip the Cold Weather Start Lever to RUN / OPEN
Flip the Cold Weather Start Lever to CLOSED / START and
follow the Starting Instructions
A C T I O N
Replace or clean the air filter
Drain gas tank and add fresh fuel
Adjust according to the Carburetor Adjustments section or take
to an authorized service dealer for an adjustment
A C T I O N
Drain gas tank and add fresh fuel
Adjust according to the Carburetor Adjustments section or take
to an authorized service dealer for an adjustment
Stop the engine and clean the cutting attachment
Clean or replace the air filter
Clean or replace spark arrestor
A C T I O N
Drain gas tank and add fresh fuel
Adjust according to the Carburetor Adjustments section or take
to an authorized service dealer for an adjustment
Replace or clean the spark plug
Clean or replace spark arrestor
A C T I O N
Stop the engine and clean cutting attachment
Refill with new line
Replace the inner reel
Clean inner reel and outer spool
Disassemble, remove the welded section and rewind
Disassemble and rewind the line
Push the bump knob and pull out line until 4 inches (102 mm) of
line is outside of the cutting attachment
A C T I O N
Clean and thoroughly dry the cutting head
15