Cub Cadet CC4105 Manual Del Operador página 9

NOTE: Always use the correct line length when installing
trimming line on the unit. The line may not release properly if
the line is too long.
Single Line Installation
Go To Step 8 for SplitLine™ Installation
6. Take approximately 16 feet (5 m) of new trimming line, loop it
into two equal lengths. Insert each end of the line through one
of the two holes in the inner reel (Fig. 19). Pull the line through
the inner reel so that the loop is as small as possible.
7. Wind the lines in tight even layers, onto the reel (Fig. 20). Wind
the line in the direction indicated on the inner reel. Place your
index finger between the two lines to stop the lines from over-
lapping. Do not overlap the ends of the line. Proceed to step 11.
SplitLine™ Installation
8. Take approximately 8 feet (2.5 m) of new trimming line. Insert
one end of the line through one of the two holes in the inner
reel (Fig. 21). Pull the line through the inner reel until only
about 4 inches is left out.
9. Insert the end of the line into the open hole in the inner reel
and pull the line tight to make the loop as small as possible
(Fig. 21).
10. Before winding, split the line back about 6 inches.
11. Wind the line in tight even layers in the direction indicated
on the inner reel.
MAINTENANCE AND REPAIR INSTRUCTIONS
Loop
Fig. 19
Fig. 20
Fig. 21
NOTE: Failure to wind the line in the direction indicated will cause
the cutting attachment to operate incorrectly.
12. Insert the ends of the line into the two holding slots (Fig. 22).
13. Insert the ends of the line through the eyelets in the outer
spool and place inner reel with spring inside the outer spool
(Fig. 23). Push the inner reel and outer spool together.
While holding the inner reel and outer spool, grasp the
ends and pull firmly to release the line from the holding
slots in the reel.
NOTE: The spring must be assembled on the inner reel before
reassembling the cutting attachment.
14. Hold the inner reel in place and install the bump knob by
turning clockwise. Tighten securely.
Installing a Prewound Wheel
1. Hold the outer spool with one hand and unscrew the bump
knob counterclockwise. Inspect the bolt inside the bump
knob to make sure it moves freely. Replace the bump knob if
damaged (Fig. 15).
2. Remove the old inner reel from the outer spool (Fig. 15).
3. Remove the spring from the old inner reel (Fig. 15).
4. Place the spring in the new inner reel.
Loop
NOTE: The spring must be assembled on the inner reel before
reassembling the cutting attachment.
5. Insert the ends of the line through the eyelets in the outer
spool (Fig. 23).
6. Place the new inner reel inside the outer spool. Push the inner
reel and outer spool together. While holding the inner reel and
outer spool, grasp the ends and pull firmly to release the line
from the holding slots in the spool.
7. Hold the inner reel in place and install the bump knob by
turning clockwise. Tighten securely.
Fig. 22
Eyelet
Fig. 23
Holding Slots
Eyelet
Spring
9